In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc. Tolerances are typically specified in thousandths of an inch or hundredths of a millimetre.
Attributes | Values |
---|
rdfs:label
| - Tolérance d'usinage (fr)
- Limits and fits (en)
|
rdfs:comment
| - In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc. Tolerances are typically specified in thousandths of an inch or hundredths of a millimetre. (en)
- L'imprécision inévitable des procédés d'élaboration fait qu'une pièce ne peut pas être réalisée de façon rigoureusement conforme aux dimensions nominales fixées au préalable sur le plan. On est donc dans l'obligation de se dire que chacune des dimensions de la pièce effectivement réalisée est comprise entre deux cotes limites, compatibles avec un fonctionnement correct de la pièce. La différence entre ces deux dimensions constitue la tolérance. (fr)
|
dcterms:subject
| |
Wikipage page ID
| |
Wikipage revision ID
| |
Link from a Wikipage to another Wikipage
| |
Link from a Wikipage to an external page
| |
sameAs
| |
dbp:wikiPageUsesTemplate
| |
has abstract
| - In mechanical engineering, limits and fits are a set of rules regarding the dimensions and tolerances of mating machined parts if they are to achieve the desired ease of assembly, and security after assembly - sliding fit, interference fit, rotating fit, non-sliding fit, loose fit, etc. Tolerances are typically specified in thousandths of an inch or hundredths of a millimetre. (en)
- L'imprécision inévitable des procédés d'élaboration fait qu'une pièce ne peut pas être réalisée de façon rigoureusement conforme aux dimensions nominales fixées au préalable sur le plan. On est donc dans l'obligation de se dire que chacune des dimensions de la pièce effectivement réalisée est comprise entre deux cotes limites, compatibles avec un fonctionnement correct de la pièce. La différence entre ces deux dimensions constitue la tolérance. (fr)
|
gold:hypernym
| |
prov:wasDerivedFrom
| |
page length (characters) of wiki page
| |
foaf:isPrimaryTopicOf
| |
is Link from a Wikipage to another Wikipage
of | |
is foaf:primaryTopic
of | |