A phototool is a printed film used in the process of manufacturing a printed circuit board (PCB). The phototool is used as a mask to expose a photoresist material. The main alternative to using phototools is maskless lithography, more commonly referred to as direct imaging. Traditionally, phototools were made with or diazo film, but in recent years, many suppliers have come out with films that do not fit into either of these categories. All dry-film phototools are printed using a similar process to film photograph. The steps for using a phototool are as follows:
Attributes | Values |
---|
rdfs:label
| |
rdfs:comment
| - A phototool is a printed film used in the process of manufacturing a printed circuit board (PCB). The phototool is used as a mask to expose a photoresist material. The main alternative to using phototools is maskless lithography, more commonly referred to as direct imaging. Traditionally, phototools were made with or diazo film, but in recent years, many suppliers have come out with films that do not fit into either of these categories. All dry-film phototools are printed using a similar process to film photograph. The steps for using a phototool are as follows: (en)
|
dcterms:subject
| |
Wikipage page ID
| |
Wikipage revision ID
| |
Link from a Wikipage to another Wikipage
| |
Link from a Wikipage to an external page
| |
sameAs
| |
dbp:wikiPageUsesTemplate
| |
has abstract
| - A phototool is a printed film used in the process of manufacturing a printed circuit board (PCB). The phototool is used as a mask to expose a photoresist material. The main alternative to using phototools is maskless lithography, more commonly referred to as direct imaging. Traditionally, phototools were made with or diazo film, but in recent years, many suppliers have come out with films that do not fit into either of these categories. All dry-film phototools are printed using a similar process to film photograph. The steps for using a phototool are as follows:
* A PCB (typically consisting of a laminate material with copper adhered to the surface) is prepared and cleaned.
* The PCB is coated with a photoresist material that can be cured with UV light
* The phototool is positioned over the PCB
* UV light (or other actinic radiation) shines through the phototool, selectively curing the material.
* The uncured material is washed away, usually using a mild water-based alkali solution.
* PCB can continue to a photolithography step such as surface plating, or a photoengraving step such as etching away unwanted material. (en)
|
prov:wasDerivedFrom
| |
page length (characters) of wiki page
| |
foaf:isPrimaryTopicOf
| |
is Link from a Wikipage to another Wikipage
of | |
is foaf:primaryTopic
of | |